Getting Started With Networking

Hi Guys,

Before posting anything in this tab, i want to clear that this is not a networking tutorial instead a reference guide.


Thanks & Regards

Amit Chowrasia

Comments

Post a Comment

Popular posts from this blog

Windows Alt Key Code

Image
In Microsoft Windows, holding down the Alt key while typing in numbers (often referred to as Alt codes) on the numeric keypad allows the user to type special characters not normally available on the keyboard.  Example Alt+255 this is the code for blank space List of the code are shown below with u can use  Trick : You can create a nameless folder by using this method. Step 1: Create a new folder. Step 2: right click on the folder and select rename or use F2  Step 3: and then press and hold Alt key and type 255 After that u will have a nameless folder like this
Read more

Subnetting

Image
Learning subnetting is much easier that it looks. All you need is basic understanding of  IP Addressing and Maths Formulas Of Subnetting 1. Number of Valid Host (2n-2) Where n is number of Host bits (0's) 2. Number of Valid Network (2y) Where y is number of borrowed Network bits   (1's) NOTE : With ip-subnet command we can use 1st & last ip NOTE : Block size remain same for all classes Learn the following table or save it for solving subnetting much faster.   Wild Card is always 1 less then block size. Example : \30 Wildcard will be (Block size -1) (4-1) =3 \30= 0.0.0.3
Read more

Resetting BIOS from CMD

This method works only if you have access to the system when its turned on because this method requires MS DOS. Open Command Prompt from Programs menu and provide following commands one bye one: debug o 70 2E o 71 FF quit NOTE: The first character in the above commands is English alphabet "o" and not the number 0. After providing the above commands, restart your system and it should reset the CMOS Settings along with the BIOS password. If you are curious to know how it works? then let me explain the above commands: In this method we are using the Debug tool of MS DOS. The "o" character present at first in these commands, outputs the values to IO ports. The number 70 and 71 are port numbers which are used to access CMOS memory. By providing FF value we are telling CMOS that there is an invalid checksum and it resets the CMOS settings as well as BIOS password.
Read more